Introduction
Are you tired of the constant drip, drip, drip of a leaky bath tap? Not only is the sound annoying, but it can also lead to water wastage and higher utility bills. The good news is that fixing a leaky bath tap is a relatively simple DIY task that can be done with just a few basic tools.
1. Turn Off the Water Supply
The first step in fixing a leaky bath tap is to turn off the water supply to the tap. This can usually be done by turning off the isolation valve located beneath the sink or bath. If you can’t find the isolation valve, you may need to turn off the main water supply to your home.
2. Remove the Handle
Once the water supply is turned off, you can start by removing the handle of the tap. This can usually be done by unscrewing a small screw located underneath a cover on the handle. Use a screwdriver to carefully loosen and remove the screw.
3. Remove the Cartridge
After removing the handle, you will see the cartridge inside the tap. Use a wrench to carefully unscrew the cartridge and remove it from the tap. Inspect the cartridge for any signs of damage or wear, such as cracks or mineral buildup.
4. Replace the Cartridge
If the cartridge is damaged, it will need to be replaced. Take the old cartridge to your local hardware store to find an exact replacement. Once you have a new cartridge, carefully insert it into the tap and screw it back into place using a wrench.
5. Reassemble the Tap
Once the new cartridge is in place, reassemble the tap by screwing the handle back on and tightening the small screw underneath the cover. Make sure everything is securely in place before turning the water supply back on.
6. Turn On the Water Supply
After reassembling the tap, turn the water supply back on and check for any leaks. If there are no leaks, congratulations, you have successfully fixed your leaky bath tap! If there are still leaks, you may need to repeat the steps above or seek professional help.
7. Test the Tap
Once the water supply is back on, test the tap to ensure that it is working properly. Turn the tap on and off a few times to make sure there are no more drips or leaks. If everything looks good, you can enjoy a leak-free bath experience once again.
8. Clean Up
After fixing the leaky bath tap, don’t forget to clean up any tools or debris left behind. Wipe down the area around the tap to remove any water or residue and make sure everything is back in its place.
9. Check for Other Leaks
While you’re at it, take the time to check for any other leaks in your bathroom or home. Fixing leaks promptly can help prevent water damage and save you money in the long run.
10. Share Your Experience
Don’t forget to share your experience of fixing a leaky bath tap with others. You never know who might benefit from your newfound DIY skills. Happy fixing!